2024 Rules

 

General Rules

No Tire Rule

MyLaps Transponders & RACEceivers Are Required

Frequency 454.000

MyLaps Transponders & RACEceiver Rentals Are Available

Transponder Mounting Location For All Classes Will Be On Steering Shaft Close To Bottom Of Kart

Burris Rules

AKRA Rules As Printed For 2024

WKA Rules Apply To Animals & Flatheads

AKRA Rules Apply To Clones

All Jr. Drivers Must Wear Chest Protector

 

Class Rules

 

Rookie A:

This Is A Learning Exhibition Class With No Points

Dominate Karts/Drivers Will Be Moved Up

Driver Requirement: First Year Racers

Minimum Weight: 200# (kart & driver)

General Rules: WKA

Fuel: Gasoline (87 octane)

Engine: Bone Stock Predator Motor 79cc

Drum Clutch

Bone Stock Predator Only

Possible RPM Rule ???

 

Rookie B: 

Engine: Bone Stock 212cc Predator

Restrictor Plate: Red

Minimum Weight: 225# (Kart & Driver)

 

Jr. 1:

Driver Requirement: Ages 5-10

Minimum Weight: 250# (kart & driver)

General Rules: WKA

Engine: AKRA Clone Motor (196cc)

Restrictor Plate: .425 (Green)

Fuel: Gasoline (87 octane)

Pipe: Any single stage, one piece header made from .750” OD steel tubing, with  RLV Mini  B-91 Silencer installed thread fitted at the end of the pipe. Maximum length including  muffler 15”, minimum 10”. AKA: WIENIE PIPE

 

Jr.  2: 

Driver Requirement: Ages 10-12

Minimum Weight: 275# (kart & driver)

General Rules: WKA

Engine: AKRA Clone Motor (196cc)

Restrictor Plate: .500 (purple)

Fuel: Gasoline (87 octane)

Pipe: Any single stage, one piece header made from .750” OD steel tubing, with RLV Mini B-91 Silencer installed thread fitted at the end of the pipe. Maximum length including  muffler 15”, minimum 10”. AKA: WIENIE PIPE

 

Jr. 3: 

Driver Requirement: Ages 12-15

Minimum Weight: 300# (kart & driver)

General Rules: WKA

Engine: AKRA Clone Motor (196cc)

Restrictor Plate: .550 (blue)

Fuel: Gasoline (87 octane)

Large Pipe

 

Jr. Predator:

Driver Requirement: Ages 7-14

Minimum Weight: 300# (kart & driver)

Engine: Predator Motor (212cc)

Restrictor Plate: .500 (Purple)

Fuel: Gasoline (87 octane)

 

Jr. Cage:

Driver Requirement: Ages 8-14

Minimum Weight: 275# (Kart & Driver)

General Rules: WKA

Motor Option #1

Engine:  Briggs & Stratton 6.5 hp. Animal.

Restrictor Plate: .225 - 3-hole (purple)

Fuel: Methanol

Motor Option #2

Engine: AKRA Clone Motor (196cc)

Restrictor Plate: .425 (green)

Fuel: Gasoline (87 octane)

Pipe: Open Pipe

 

Jr. Cage Wing: 

(Must Have Wing)

Driver Requirement: Ages 8-14

Minimum Weight: 275# (Kart & Driver)

General Rules: WKA

Motor Option #1

Engine:  Briggs & Stratton 6.5 hp. Animal.

Restrictor Plate: .225 - 3-hole (purple)

Fuel: Methanol

Motor Option #2

Engine: AKRA Clone Motor (196cc)

Restrictor Plate: .425 (green)

Fuel: Gasoline (87 octane)

Pipe: Open Pipe

 

Clone 350:

Driver Requirement: Ages 15 & over

Minimum Weight: 350# (kart & driver)

Engine: AKRA Clone Motor (196cc)

Fuel: Gasoline (87 octane)

Pipe: Open Pipe

 

Flathead 350:

Driver Requirement: Ages 16 & over

Minimum Weight: 350# (kart & driver)

Engine: Briggs & Stratton 5 hp Flathead

Fuel: Methanol

 

Predator 360:

Weight: 360# (kart & driver)

Age: 14+

1. Engine must be run out of box.

2. You can remove the governor but you don't have to.

3. You can remove the oil sensor.

4. Air filter and sock must be installed per factory.

5. Engine must have a key way installed by factory on the flywheel.

6. You  may disconnect throttle top screw.

7. You must run factory gas tank.

8. You can only bolt on a chain guard.  No aftermarket add ons.

9.  You can vent the gas cap. (per safety, the cap must be taped down)

10. No engine builder stickers on these motors.  They are stock motors.

11. Fuel: 87 Octane only

12. Carburetor: Must remain stock (no alterations)

13. Engine:  Predator 212 cc engines No exchanging or mixing of parts between motors.

14. Cylinder head:  Must be OEM Predator type casing only.  Intake and Exhaust ports must remain as factory produced.  Porting or deburring is not permitted.  Transition edge from port runner to bowl area must retain defined edge.  Head gasket surface must remain stock.  No copper or aluminum gaskets.

15. Valve: stock valves only

16. Valve Train:  must use stock pushrods, rocker arms, retainers and valve springs.  No alterations or aftermarket valve train components allowed.

17.  Camshaft must remain stock.

18.  Crank rod and piston must be factory without any modifications.  Stock piston rings.

19. You must run the stock head gasket.  No thin head gaskets.

20.  We recommend a full length bumper that extends the length of the rear wheels for added safety.

**If you refuse tech, you will be removed from the class for the remainder of the season**

**If your engine is found to be modified after tech, you will be disqualified and removed from the class for the remainder of the season**  (All points will be forfeited)

**If a driver wins a certain amount of races (to be determined yet), the track will take your motor and give you another one.  (Brand new in box)


Sr. Wing Rules

Bore 2.756”-70mm Max Stroke 2.165+ or -.010 Max. (212cc)

Engine Block Predator Or Tillotson (Must Have Bill Of Sale From Supplier)

Exhaust - All pipes must use mufflers. Baffles must be in place.

Floor Mounts fuel tank mandatory. Any pulse type fuel pump.

Clutch – Disc Or Drum shoe type.

Carburetor – Any type 22mm venturi (.866 inch) Max.

Piston –  2 Piston (No Forged Pistons)

Crankshaft – Predator Or Tillotson

Flywheel- Billet Aluminum 3.3lb. Minimum

Ignition Coil – Stock predator coil or stock Tillotson

Cast Aluminum heads only. No Billet Heads. Porting & Milling allowed. Valves may be stock or stainless steel. Single valve spring only. Valve sizes- Intake 27mm Max. Exhaust 25mm. Max

Value Train – Rocker arms may be stock roller. Ratio rockers allowed.

Camshaft – May be any type but valve lift cannot exceed .300” at valve spring retainer both intake & exhaust

Fasteners – Non-Tech

Gaskets - Non-Tech

Crankshaft bearings must be metallic (no other material).

Connecting Rod – Billet Aluminum 3.403” Max Length

Fuel Type: Gas Or Alcohol

Wing Size:

Center 32x35

Left Board 40x20

Right Board 40x14

Must Within +/-2”


Also feel free to contact Dick at 814-592-7453 to verify legality of any parts before purchase (For Sr. Wing Class).

 

Rules Subject To Change As Needed For Fair Competition & Safety